So I installed the demo of I Am Alive, and after about 5 minutes into the demo it beeped (I think 3 times).
Now whenever I try to turn it on I see the led light go green, then turns red and beeps 3 times.
Is my PS3 dead???
Is there a way to fix it?
Results 1 to 12 of 12
HELP: PS3 won't come on after I Am AliveThou shall not question my lame sig
Its the YLOD unfortunately. Try turning it on and backing up your important saves if possible.
- Join Date
- Oct 2006
- Australia, In a Kangaroo's pouch.
- Rep Power
I guess your PS3 can't say "I Am Alive."
A PS4 is sold every 2s.
Admartian likes this post
Yep ylod. replace the thermal paste grab the gamesaves and buy a new ps3Six Years With PSU!~ Favourite Games of all Time~ Smash Bros, Spyro, GTA series and Elder Scrolls Series
Add me on PSN FOXY007 OR Steam psn_foxy007
My Hardware~ Sony Bravia 240hz 3D 40".. Ps3 Slim250gig and Sony Bravia Surround Sound 5.1
PC- i7 3930k|gtx670|8g ram|2T HDD|Bluray disc drive
Crap; I was expecting to see something like the blue screen of death when it YLOD.
Thank you for the help.Thou shall not question my lame sig
That or it over-heated. Wait half an hour and turn it back on. If the problem persist then I suggest the oven fix. That's how I fixed my PS3's yellow light. Here are some steps you should take(I'm assuming that it's a Phat model?).
1. Try the above method of waiting before turning it back on. If it works then immediately delete the game. Apparently there are some nasty issues with the title "I Am Alive" that freeze your console among other problems.
2. (In case the above method doesn't work) - If your console still has warranty then call Sony to have it replaced, if not then either buy a new slim model or fix it yourself in the below process(Note: Must have Thermal Paste for this to work)
*Find an empty space to work with and take your console apart. Take pictures to figure out where everything goes before removing the pieces - Remove everything until your motherboard is free.
*Look at your motherboard and find two chips that are parallel to each other. If they have thermal paste on them then wipe it out.
*Take your motherboard and place it in a lasagna-tinfoil pan. Turn on your oven and set the heater to 420 degrees at 11 minutes!(STAY WITH IT AT ALL TIMES!). After baking, set it outside for half an hour to cool off. Make sure you turn off your oven after use(Safety advice from the fonman).
*After it's cool then find the two chips parallel to each other and apply a thin layer of Thermal Paste on each one(It better be good quality paste).
*Re-assemble your console. Connect everything in their right places and screw in all the bolts in their appropriate place.
*Finally, hook up your console and pray that it works XD
That's all the help I can give you.
Videogame: I am alive
Console: I am dead
Obligatory Tapatalk Signature
By recognizing the difference between you and others you establish your identity as yourself
Users Browsing this Thread
There are currently 1 users browsing this thread. (0 members and 1 guests)